Most of my projects don’t require ripping long workpieces. But occasionally I need additional table saw outfeed support for long workpieces. Rather than drilling holes in my fence rails and bolting on a table, I came up with the solution you see here. It’s just an MDF top wrapped with hardwood. But the key to this table is the two switchable, magnetic clamps from Magswitch (inset photo).
These clamps are attached to a mounting rail located at one end of the table. With just a turn of a knob, I can quickly attach or remove the table from my saw.
On the other end of the table are two hardwood legs. They’re connected to the underside of the table with folding leg brackets that allow the legs to be stored away. This makes storing the table a breeze.
