Updates & Revisions - Woodsmith Magazine

Updates & Revisions

Here you will find important updates and revisions to the articles and plans published in Woodsmith magazine.

Woodsmith Issue 222 cover image

December 2015
Issue 222

Sources
Page 67: ROUTER TABLE sources
The part #1030A15 at McMaster Carr is for a plate that is 1 7/8" x 1 7/8"—this is incorrect. The listing should instead be for part #1030A4, which is a 1" x 3" plate with 2 mounting holes.
Combination Router Table
Page 38: Detail 'c'
We show a callout for (1 1/4"-dia. counterbore, 3/4"-deep) but we do not show the diameter of the through hole. This should be called as (9/16" dia. hole) to fit a 1/2"-13 T-nut.
Page 40: Detail 'a'
The lower 1 1/2" dimension (showing from the left edge of the board to center of hole) should be 1 3/4". The 6" dimension should be 5 3/4".
Page 36: Detail 'c'
The 2-3/4" dimension shown on part 'A' for locating the left hole should be 3-11/16" instead.
Page 37: Detail 'a'
The 3" dimension for locating the 1-1/2"-dia. hole on part 'F' should instead be 3-15/16"
Page 36: Main Illustration
The dimensions for locating the two inner dadoes on the top face of Case Top (B) are not given. The inner dadoes are 5 3/4" away from the outer dadoes (edge-to-edge).
Double Porch Rocker
Page 46: Detail 'b'
The angle for the top of the rear legs isn’t dimensioned clearly in details 'a' and 'b' on page 46. In detail 'b' the front and back edge of the leg should be extended to the top of the blank. There should be a callout dimension showing that the front edge of the leg is 1 9/16" from the front edge of the blank. The rear edge of the leg should extend to the upper left corner of the blank.
Page 46: Detail 'a'
The distances between the bottom of the mortises for the back should be 14 1/2", not 14 3/4".
Shop Notes
Page 65: Main Illustration
The hole on the left side should be 7/8" from the end of the jig, not the 1-1/2" shown. The hole on the right side should be 1-5/8" from the end of the jig, not the 1-1/2" shown.
Page 65: Main illustration
In the art for the Back Assembly Platform the length of the End holding block should be 15 1/2", not 15 1/4".