Updates & Revisions
Here you will find important updates and revisions to the articles and plans published in Woodsmith magazine.
April 2011
Issue 194
- Contoured Keepsake Box
- Page 27: Materials, Supplies & Cutting Diagram
- Two Corrections: (1) The continuous brass hinge should be 780mm, not 800mm as originally printed. The part number on the sources page is correct. (2) The supplies list indicates just one piece of veneer for the lid; however to cover both faces requires two pieces.
- Page 27: Materials List
- Clarification: The continuous hinge from Lee Valley calls for a #2 screw, but for this project we used a #1 screw because it was a better fit. The materials list and sources information are both correct.
- Page 27: Cutting diagram
- The cutting diagram shows a piece of 12" x 48" plywood is needed for the bottom and lid panel. However the piece should be 12" x 24".
- Entertainment Center
- Page 51: Sources
- The catalog number listed for the hinges is incorrect. The correct number should be 00B15.34.
- Page 33: Materials, Supplies & Cutting Diagram
- The Supplies section calls for three 48" x 96" sheets of 3/4" Birch plywood; however the project requires five sheets.
- Page 33: Materials, Supplies & Cutting Diagram
- The project requires three sheets of 1/4" plywood, not two as originally printed.