Give a Gift FREE Book
URL:
https://www.woodsmith.com/article/make-your-own-deluxe-zero-clearance-insert-plates/
Share Page:

Make Your Own Deluxe Zero-Clearance Insert Plates

By: Phil Huber
Replacing the insert in your table saw is one of the easiest ways to increase the quality of the cuts you make, but purchasing new ones can get rather costly. Phil has a solution for a shop-made insert that can save you a lot of time and money while improving the performance of your table saw.

Ripping is usually a pretty simple task. When the workpiece is fairly narrow, however, I often run into a challenge. The strip falls into the opening between the saw blade and the insert. I needed to find a way to keep this from happening. Otherwise, a strip can get wedged into the opening and kick back. Fortunately, the solution is simple — replace the metal insert that comes with the table saw with a zero-clearance insert that has an opening that’s the same width as the blade, like the one shown in the photo below.

Screenshot 2021-04-19 105635

This prevents a strip from getting jammed in the opening. And since the insert supports the workpiece right up next to the saw blade, it also reduces chipout on the bottom. Although the idea of a zero-clearance insert has been around awhile, this one has a couple of advantages over others I’ve seen.

Screenshot 2021-04-19 110446

First, it’s made from a special material called Ultra-High Molecular Weight (UHMW) plastic. This plastic is extremely slick, so the workpiece glides across the insert as you make a cut. Another thing I like about UHMW plastic is that it won’t expand and contract with changes in humidity. So once I cut it to fit a particular jig, I don’t have to worry about it binding (or getting sloppy) as the seasons change.

Screenshot 2021-04-22 094910

Another unique thing about this insert is that it has a replaceable filler strip. This way, if you have several different blades that cut different width kerfs, you can just slip in the correct filler strip.

Screenshot 2021-04-19 111530

You can also add a splitter to this replaceable insert. It’s a piece of 1⁄8" hardboard that fits in a slot in the end of the filler strip. Once the short slot is cut, you can glue in the splitter. Then, to avoid “catching” a workpiece, simply sand the leading edge to a point.

The only thing left to do is add some leveling screws and you're ready to start making clean, safe cuts at the table saw.

Published: April 19, 2021
Share Page:
Topics: None

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

SHN_5FreePlans_300x250

WSM Sidebar Ad_PlywoodProjectsSIB

Related Articles