Updates & Revisions
Here you will find important updates and revisions to the articles and plans published in Woodsmith magazine.
February 2001
Issue 133
- Heavy-Duty Workbench
- Page 7: Materials, Supplies
- Quantity of piece C (Lower End Rails) should be 2, not 4 as printed.
- Page 7: Cutting Diagram
- Cutting diagram for pieces F, I, M, T, and V indicates board width of 7 1/4" but it should be 9 1/4".
- Page 12: Figure 11, detail a
- Two incorrect measurements. 1. From lower left corner of top view, distance up to first drill hole printed as 1 1/2" but should be 3". 2. Distance from lower left corner over to first hole shown as 2" but should be 3 1/2".